DIY H1 1 Bar Aluminum System (Drilling Required)
Click To Enlarge


Instruction Manual
(Right-click to save)

  

 The Vantech H1 Aluminum Custom Rack 

This system can hold up 250-450lbs depending on where crossbar is positioned. The Cross bars is 2" x 1" reinforced extruded aluminum with built-in channels. The aluminum mounting upright is approx. 1/8" thick at the base. The mounting uprights are 8" wide at the base and 28.5" Maximum total height. The Base is welded complete onto the upright post for complete seal. There are four 3/4" eyehook per mounting upright There is absolutely No drilling required for installation (drilling required for assembly), secures with drip rail clamps. The drip rail clamps are 11 gauge galvanized steel & powder coated 2" x 8" dipped in rubber top and bottom. Rubber cap on the upright post prevents wind noise and water leaking into post.

 

 

- Clamps onto factory drip rails

- Customizable upright height clearance (drilling required)

- Addition of cross bars can increase load capacity

- 28.5” total post height mounting base

- 4 x .75” eyehooks per mounting base for easy tie down

- Colors available: black or white 

- 2 bar roof top clearance 3” - 10” max load capacity 450lbs

- 2 bar roof top clearance 11” - 14” max load capacity 400lbs

- 2 bar roof top clearance 15” - 18” max load capacity 350lbs

- 2 bar roof top clearance 19” - 22” max load capacity 300lbs

- 2 bar roof top clearance 23” - 23.5” max load capacity 250lbs

- Material: Aluminum

 

 
___________________________________

Assembly information


A-Total Height of Upright Mounts (28.5").
     Upright Mounts can be shortened to desired
     height (See "D")

B-Minimum roof top clearance.
     Minimum height to clear roof top
     (Also marked on instruction's Template) 

C-Optional Conduit Carrier.
     Add an additional 7" to roof top clearance "B".


D-Minimum height of Upright Mount.
     Cannot be lower than 5" from bottom 
     of cross bar to allow for Sleeves & Endcap. 

     (Clearance "A" must be 5" more
     than Clearance "B")


E-Optional Ladder Stopper/Guide.

     Add an additional 2" to roof top clearance "B". 

 

 ___________________________________

 

  • Item #: H-CUSTOM-AL

DIY H1 1 Bar Aluminum System (Drilling Required)

Price: $259.00
Sale Price: $233.10
* Marked fields are required.
Qty: *